Quick Dry Timberlife
Protect and add the life of outdoor timer and garden timber. Highly water repellent and resist to fading. It is also harmless to pets and plants with range of attractive colors. The high quality acrylic binders, preservatives and waxes give all weather, moisture, rot and mould protection. The special pigments resistant to ultra violet light and fading.
Features
- Water based single product system and maximum two coats required.
- Water based single product system and maximum two coats required.
- Keep and preserve the natural look of wood grains with clear and color ranges.
- Penetration agent with low VOC and doesn't peel off
- Penetration agent with low VOC and doesn't peel off
- Highly water repellent, low odour and harmless to pet and plants
- It contains fungicides to give long lasting protection from rot and mould
- Special pigments which resist UV light and fading
- Up to 5 years protection
- Pack Size 1Ltr, 5Ltr
Product Application Guide
Quick Dry Timberlife is readymade exterior wood protective coating/polish in pigmented and natural color in silk matt finish that penetrates deeply inside the porous part of wood. The coating is translucent coating.
Step-1
- If the surface is already painted or polished, remove with the help of paint remover or sand paper till the actual wood comes in a condition to absorb the readymade polish.
- If any filling is required for smoothening the surface, it should be done with filling putty or with POP and chalk mitti and not with fevicol
- If required, first sand the surface with 80 no., and thereafter with 120 no., 320 no. water proof sandpaper.
- All sanding to be done in the direction of the grains of the wood.
Step-2
- First Coat: Stir well and apply the material with a soft brush (paint brush), roller or spray gun on the well prepared surface in the direction of the grains of the wood. (if surface temperature is more than 380C then add 10-20% potable water)
- Let it dry for at least 2 - 4 hours.
- If require do the soft sanding with more than 600 no. waterproof sandpaper to remove the superficial particles. All sanding should be done in the direction of the grains.
Step-3
Second Coat: Apply second coat of material with a soft brush, roller or gun. If surface temperature is more than 380C then add 10% potable water in second coat also.
- Note: The consumption may vary due to porosity of substrate, so for huge surface a trial is required.
- For Interior one coat of material is sufficient, but for enhancing the glass and finish can take additional one coat after soft sanding with more than 600 water based sand paper.
- The all application will be done towards the direction of wood gain.